User Manual
Table Of Contents
- WARNING SUMMARY
- 1. WELCOME AND INTRODUCTION
- 2. GETTING TO KNOW YOUR ARMOR X7
- Processor and Operating System
- Data Storage
- Dual Screen Display
- Video Graphics
- Wireless
- Optional GPS Capability
- Audio
- Batteries
- ARMOR Flexspace™
- ARMOR X7 Specifications
- Front Panel Features
- Rear Panel Features
- Bottom Panel Features
- Included Components, Accessories and Support
- Optional Accessories for Your X7
- 3. GETTING STARTED
- Installing and Charging the Batteries
- Turning On Your X7 for the First Time
- Turning the Computer On Normally
- Putting the Computer in Sleep Mode
- Turning the Computer Off Normally
- Emergency Shutdown
- Indicator State Summary
- Activating your Wireless Radios
- Installing a Micro SD or SDHC Card
- Accessing and Using the GPS Receiver
- Operating the X7 Display
- Working with the Pen Screen
- Working with the Touch Screen
- Entering Data Using the Input Panel
- Using the FPS as a Simple Mouse Device
- Configuring Your Speakers
- Operating with the ARMOR X7 Vehicle Dock
- Using the Webcam
- Using the Screen Magnifier
- Tips for Proper Use and Care Of Your X7
- 4. NETWORKING
- 5. YOUR ARMOR X7 SOFTWARE
- Getting Started with Windows 7
- ARMORutils Program
- ARMORutils Main Dialog Window
- Backlight Setup Dialog Window
- Wireless Devices Dialog Window
- Programmable Button Settings Dialog
- Configuration Dialog Window
- Battery Monitor Dialog Window
- Screen Mode Setup Dialog Window
- Diagnostics Dialog Window
- ARMORutils About Window
- Pen and Touch Utility
- Tablet PC Settings Utility
- Pen Tablet Properties Utility
- Picasa 3®
- Virtual Magnifying Glass™
- 6. TROUBLESHOOTING
- 7. BACKUP AND RESTORE PROCEDURES
- 8. MAINTAINING YOUR ARMOR X7
- 9. DISPLAY MANAGEMENT
- 10. BATTERY MANAGEMENT
- Safety and Handling Considerations for Your Batteries
- When to Charge a Battery
- How to Charge Your Batteries
- How to Tell When Batteries Have Finished Charging
- Battery Operating Time
- Operating under Low Battery Conditions
- Battery Capacity
- Discharge/Recharge Cycles
- Battery Conditioning
- How to Optimize Battery Operating Time
- How to Monitor Battery Usage
- When to Replace a Battery
- Battery Warranty
- Where to Purchase Replacement Batteries
- How to Store Batteries When Not in Use
- Battery Tips for Best Performance
- Disposing Of Your Batteries
- 11. DRS TECHNICAL SUPPORT
SECTION 10 BATTERY MANAGEMENT PAGE 171
9711-26400-0001
EXPORT CONTROLLED – SEE PAGE 3
Rev -
NOTE
The conditioning process can take 3-
5 hours to complete. Ensure
external power remains connected for the duration of the
conditioning period.
NOTE
If the internal battery temperature exceeds 45°C during conditioning,
the charging circuit will suspend the conditioning cycle until the
temperature drops back into the normal operating range.
Table 33. Conditioning a Battery
STEP ACTION CONDITION OR INDICATION
1.
Connect external power.
2.
Open the Battery and Charger Monitor
page in ARMORutils
and Click on the
Conditioning Menu button.
The Battery Conditioning window opens,
as shown in Figure 89.
3.
Select Bay 1 Only, Bay 2 Only or All
Bays
4.
Click on Start Cycle.
5.
To terminate the conditioning process at
any time, click on Terminate Cycle.