User Manual
Table Of Contents
- WARNING SUMMARY
- 1. WELCOME AND INTRODUCTION
- 2. GETTING TO KNOW YOUR ARMOR X7
- Processor and Operating System
- Data Storage
- Dual Screen Display
- Video Graphics
- Wireless
- Optional GPS Capability
- Audio
- Batteries
- ARMOR Flexspace™
- ARMOR X7 Specifications
- Front Panel Features
- Rear Panel Features
- Bottom Panel Features
- Included Components, Accessories and Support
- Optional Accessories for Your X7
- 3. GETTING STARTED
- Installing and Charging the Batteries
- Turning On Your X7 for the First Time
- Turning the Computer On Normally
- Putting the Computer in Sleep Mode
- Turning the Computer Off Normally
- Emergency Shutdown
- Indicator State Summary
- Activating your Wireless Radios
- Installing a Micro SD or SDHC Card
- Accessing and Using the GPS Receiver
- Operating the X7 Display
- Working with the Pen Screen
- Working with the Touch Screen
- Entering Data Using the Input Panel
- Using the FPS as a Simple Mouse Device
- Configuring Your Speakers
- Operating with the ARMOR X7 Vehicle Dock
- Using the Webcam
- Using the Screen Magnifier
- Tips for Proper Use and Care Of Your X7
- 4. NETWORKING
- 5. YOUR ARMOR X7 SOFTWARE
- Getting Started with Windows 7
- ARMORutils Program
- ARMORutils Main Dialog Window
- Backlight Setup Dialog Window
- Wireless Devices Dialog Window
- Programmable Button Settings Dialog
- Configuration Dialog Window
- Battery Monitor Dialog Window
- Screen Mode Setup Dialog Window
- Diagnostics Dialog Window
- ARMORutils About Window
- Pen and Touch Utility
- Tablet PC Settings Utility
- Pen Tablet Properties Utility
- Picasa 3®
- Virtual Magnifying Glass™
- 6. TROUBLESHOOTING
- 7. BACKUP AND RESTORE PROCEDURES
- 8. MAINTAINING YOUR ARMOR X7
- 9. DISPLAY MANAGEMENT
- 10. BATTERY MANAGEMENT
- Safety and Handling Considerations for Your Batteries
- When to Charge a Battery
- How to Charge Your Batteries
- How to Tell When Batteries Have Finished Charging
- Battery Operating Time
- Operating under Low Battery Conditions
- Battery Capacity
- Discharge/Recharge Cycles
- Battery Conditioning
- How to Optimize Battery Operating Time
- How to Monitor Battery Usage
- When to Replace a Battery
- Battery Warranty
- Where to Purchase Replacement Batteries
- How to Store Batteries When Not in Use
- Battery Tips for Best Performance
- Disposing Of Your Batteries
- 11. DRS TECHNICAL SUPPORT
REAR MATTER
PAGE 187
9711-26020-0001 Export Controlled – See Page 3 Rev -
Appendix B
Using the X7 External Battery Charger
The X7 battery charger can recharge a single battery in 2.5 hours and two batteries in less than
6 hours. You can remove or insert a battery at any time in the charge cycle without causing
damage to the charging circuits or to the battery.
Table 34. Charging a Battery
Step Action Comment
1.
Hold the battery with its connector
pointing down and the rounded edge of
the battery facing away from the
charger, as shown in Figure 93.
2.
Insert the battery into the bay and gently
press down to engage the locking
latches. Rock the battery slightly to
ensure the battery is locked in place.
The battery button will snap into place
when the latch is engaged. The charging
wil
l begin immediately, as indicated by
the steady yellow charge indicator.
When charging is complete, the yellow
LED will turn off and the green (fully
charged) LED will turn on.
3.
To remove the battery, press on the
spring-
loaded battery release button
and
lift the battery from the charging
bay.