User Manual
Table Of Contents
- WARNING SUMMARY
- 1. WELCOME AND INTRODUCTION
- 2. GETTING TO KNOW YOUR ARMOR X7
- Processor and Operating System
- Data Storage
- Dual Screen Display
- Video Graphics
- Wireless
- Optional GPS Capability
- Audio
- Batteries
- ARMOR Flexspace™
- ARMOR X7 Specifications
- Front Panel Features
- Rear Panel Features
- Bottom Panel Features
- Included Components, Accessories and Support
- Optional Accessories for Your X7
- 3. GETTING STARTED
- Installing and Charging the Batteries
- Turning On Your X7 for the First Time
- Turning the Computer On Normally
- Putting the Computer in Sleep Mode
- Turning the Computer Off Normally
- Emergency Shutdown
- Indicator State Summary
- Activating your Wireless Radios
- Installing a Micro SD or SDHC Card
- Accessing and Using the GPS Receiver
- Operating the X7 Display
- Working with the Pen Screen
- Working with the Touch Screen
- Entering Data Using the Input Panel
- Using the FPS as a Simple Mouse Device
- Configuring Your Speakers
- Operating with the ARMOR X7 Vehicle Dock
- Using the Webcam
- Using the Screen Magnifier
- Tips for Proper Use and Care Of Your X7
- 4. NETWORKING
- 5. YOUR ARMOR X7 SOFTWARE
- Getting Started with Windows 7
- ARMORutils Program
- ARMORutils Main Dialog Window
- Backlight Setup Dialog Window
- Wireless Devices Dialog Window
- Programmable Button Settings Dialog
- Configuration Dialog Window
- Battery Monitor Dialog Window
- Screen Mode Setup Dialog Window
- Diagnostics Dialog Window
- ARMORutils About Window
- Pen and Touch Utility
- Tablet PC Settings Utility
- Pen Tablet Properties Utility
- Picasa 3®
- Virtual Magnifying Glass™
- 6. TROUBLESHOOTING
- 7. BACKUP AND RESTORE PROCEDURES
- 8. MAINTAINING YOUR ARMOR X7
- 9. DISPLAY MANAGEMENT
- 10. BATTERY MANAGEMENT
- Safety and Handling Considerations for Your Batteries
- When to Charge a Battery
- How to Charge Your Batteries
- How to Tell When Batteries Have Finished Charging
- Battery Operating Time
- Operating under Low Battery Conditions
- Battery Capacity
- Discharge/Recharge Cycles
- Battery Conditioning
- How to Optimize Battery Operating Time
- How to Monitor Battery Usage
- When to Replace a Battery
- Battery Warranty
- Where to Purchase Replacement Batteries
- How to Store Batteries When Not in Use
- Battery Tips for Best Performance
- Disposing Of Your Batteries
- 11. DRS TECHNICAL SUPPORT
SECTION 3 GETTING STARTED PAGE 53
9711-26400-0001
EXPORT CONTROLLED – SEE PAGE 3
Rev -
LED IF THE
INDICATION
IS:
AND THE
POWER
MODE IS:
AND
EXTERNAL
POWER IS:
AND
BATTERY
IS:
THIS MEANS:
On steady red Power
on/off
Connected Installed Power system fault
(overvoltage,
undervoltage or
overcurrent condition
or battery failure)
Power (blue)
On On N/A Installed Computer power is on
Off Off N/A N/A Computer power is off
Fuel Gauge
(blue)
Single LED on
steady
N/A N/A Removed Total charge is
maximum for that level
(20%, 40% etc.)
LED # 1 (far
left) blinking
at 1 second
on/one
second off
rate
N/A N/A Removed Battery is below 10%
charge level (almost
depleted)
Activating your Wireless Radios
Refer to Networking for instructions on activating and using your wireless radio connections.