User Manual
Table Of Contents
- WARNING SUMMARY
- 1. WELCOME AND INTRODUCTION
- 2. GETTING TO KNOW YOUR ARMOR X7
- Processor and Operating System
- Data Storage
- Dual Screen Display
- Video Graphics
- Wireless
- Optional GPS Capability
- Audio
- Batteries
- ARMOR Flexspace™
- ARMOR X7 Specifications
- Front Panel Features
- Rear Panel Features
- Bottom Panel Features
- Included Components, Accessories and Support
- Optional Accessories for Your X7
- 3. GETTING STARTED
- Installing and Charging the Batteries
- Turning On Your X7 for the First Time
- Turning the Computer On Normally
- Putting the Computer in Sleep Mode
- Turning the Computer Off Normally
- Emergency Shutdown
- Indicator State Summary
- Activating your Wireless Radios
- Installing a Micro SD or SDHC Card
- Accessing and Using the GPS Receiver
- Operating the X7 Display
- Working with the Pen Screen
- Working with the Touch Screen
- Entering Data Using the Input Panel
- Using the FPS as a Simple Mouse Device
- Configuring Your Speakers
- Operating with the ARMOR X7 Vehicle Dock
- Using the Webcam
- Using the Screen Magnifier
- Tips for Proper Use and Care Of Your X7
- 4. NETWORKING
- 5. YOUR ARMOR X7 SOFTWARE
- Getting Started with Windows 7
- ARMORutils Program
- ARMORutils Main Dialog Window
- Backlight Setup Dialog Window
- Wireless Devices Dialog Window
- Programmable Button Settings Dialog
- Configuration Dialog Window
- Battery Monitor Dialog Window
- Screen Mode Setup Dialog Window
- Diagnostics Dialog Window
- ARMORutils About Window
- Pen and Touch Utility
- Tablet PC Settings Utility
- Pen Tablet Properties Utility
- Picasa 3®
- Virtual Magnifying Glass™
- 6. TROUBLESHOOTING
- 7. BACKUP AND RESTORE PROCEDURES
- 8. MAINTAINING YOUR ARMOR X7
- 9. DISPLAY MANAGEMENT
- 10. BATTERY MANAGEMENT
- Safety and Handling Considerations for Your Batteries
- When to Charge a Battery
- How to Charge Your Batteries
- How to Tell When Batteries Have Finished Charging
- Battery Operating Time
- Operating under Low Battery Conditions
- Battery Capacity
- Discharge/Recharge Cycles
- Battery Conditioning
- How to Optimize Battery Operating Time
- How to Monitor Battery Usage
- When to Replace a Battery
- Battery Warranty
- Where to Purchase Replacement Batteries
- How to Store Batteries When Not in Use
- Battery Tips for Best Performance
- Disposing Of Your Batteries
- 11. DRS TECHNICAL SUPPORT
SECTION 3 GETTING STARTED PAGE 61
9711-26400-0001
EXPORT CONTROLLED – SEE PAGE 3
Rev -
Working with the Touch Screen
When the touch screen is active, the pressure of a stylus tip or fingertip against the screen is
used to duplicate actions with a two-button mouse.
NOTE
Tapping with a stylus tip requires only light to moderate
pressure. It is possible to damage the pen tip and/or the display
by pounding the tip against the surface with too much force.
Working with the Touch Screen
Table 6 lists mouse-type objectives you can perform using a passive stylus (not provided) or
fingertip with the touch screen.
Table 6. Stylus Actions.
MOUSE OBJECTIVE STYLUS ACTION
Select tabs or open sub-menus.
Highlight a label or option.
Fill selection boxes.
Activate buttons.
Deselect highlighted objects or release multiple
objects
Tap once
Tap outside the object(s)
Start an application or open a folder. Tap twice
Move an object on the desktop. Press over an object, hold contact with display,
drag pen and release pressure.
Open menu options. Press over icon or option and hold contact with
display without moving pen.
Select multiple objects. Press and hold contact with display, drag box
around objects.
Touch Screen Adjustments
You can change attributes related to use of a fingertip or passive stylus with the touch screen.
Select Start à Control Panel à Hardware and Sound à and click on the Touch Settings
utility, Pen and Touch utility and the Tablet PC Settings utility.
Refer to Your ARMOR X7 Software section in the X7 User’s Guide for an explanation of these
attributes.