User's Manual

SECTION 7 TROUBLESHOOTING PAGE 140
9711-26020-0001
Export Controlled – See Page 3
Rev B
Removing and Replacing the Batteries
CAUTION!
Only one battery at a time can be removed and replaced during
operation without causing loss of data or system shutdown.
Connect external power first before removing both batteries.
NOTE
If your X10gx has only one battery, install it in the Primary Battery
compartment (see Figure 86).
Table 16. Remove and Replace a Battery
STEP
ACTION CONDITION OR INDICATION
1.
Locate the battery latch between the
two battery compartments on the
back of the unit, as shown in Figure
29. The bottom latch is for battery #1.
2.
Press in and hold
the button while
sliding the latch down.
3.
Pry up the battery and remove it.
CAUTION!
Do not force the battery into
position. If the battery will not
slip easily onto the connector,
pull it slightly toward the center
compartment wall and press in
gently.
4.
Position battery as shown in Figure
86
and gently press down on the
battery until the connector seats.