User's Manual

SECTION 7 TROUBLESHOOTING PAGE 144
9711-26020-0001
Export Controlled – See Page 3
Rev B
18.
Reinstall the batteries and reconnect
external power if desired.
Removing and Replacing a Memory Module
Two 2 GB memory modules are located in a sealed compartment at the lower left rear corner of
the tablet, as indicated in
Figure 5. Follow the procedure in Table 18 to replace a module.
NOTE
This procedure should only be performed by a qualified
technician in a controlled environment.
CAUTION!
These modules contain electrostatic discharge (ESD) sensitive
devices. Static-free handling and processing is required to
prevent possible damage to the components.
Table 18. Replacing a Memory Module
STEP ACTION condition or indication
1.
Power down the tablet and disconnect
any external power.
2.
Place the tablet face down on a clean
surface and Philips screws securing the
hard drive cover and remove the cover to
expose the memory modules, as shown
in
Figure 88 .