User manual

Tamarisk

320

Software ICD

NOTE

Note: the baud rate for the USB port is fixed at 921600.

Note: there is no acknowledge of this command, any subsequent commands

must be at the new baud rate.

The factory default setting is 57600 baud. There is a non-volatile parameter to permanently

change this. If a different baud rate is desired, there must be an initial command to change

the baud rate at 57600 baud. Or the non-volatile-parameter (#34) must be set to the desired

baud rate.

Note: the baud rate for the USB port is fixed at 921600.

Command Format:

Table 43 – Baud Rate Set Command Format

Byte Value Description

1 0x01 Start of message.

2 0xF1 Baud Rate Set Command ID.

3 0x02 Parameters length.

4, 5

Unsigned integer.

See table below.

Baud rate ID value.

6 checksum Frame check sequence.

Table 44 – Baud Rate ID Values

Baud Rate ID Baud Rate Baud Rate ID Baud Rate

0 230400 8 76800

1 115200 9 38400

2 57600 10 19200

3 28800 11 9600

4 14400 12 4800

5 7200 13 2400

6 3600 14 1200

7 1800 15 600

3.1.9 System Status Get – 0xF2

Description: This command requests system status. The response contains information

about a variety of system functions.