Providing Quality Centrifuges since 1932 Operator’s Manual Model 614B • Laboratory Centrifuge P/N 03-0-0002-0040 Rev.
Table of Contents Model Description Supplied Equipment Features Specifications Setup Location and Procedure Operation Rotor Removal and Installation Tube Holder Configurations Care and Preventative Maintenance Safety Calibration and Ground Testing Troubleshooting Replacement Parts Available Accessories Warranty WARNING: For the safety of both the operator and service personnel, care should be taken when using this centrifuge if handling substances that are known to be toxic, radioactive or contaminated wi
Features: WARRANTY: The Drucker Company warranties that this centrifuge is free from defects in workmanship and parts for 2 years.
Setup Location: Replacement Parts: 1. Unpack the centrifuge and verify that all of the supplied equipment is present. 2. Choose a setup location which meets the following criteria: a) A bench top clearance height of 20” is required in order to open the lid. b) The clearance envelope is the space around the centrifuge which is required for safety. Choose a setup location which will allow for a clearance envelope of at least 24” x 24”, (with the centrifuge at the center).
(Continued) 6. Tube Holder Replacement: It is recommended that the tube holders be replaced after 24 months of use. 7. Remove Accessories Before Moving: All tube holders, samples, and caps must be removed from the rotor chamber before transporting or storing the centrifuge to prevent damage and injury. Safety: The Model 614B complies with all requirements of UL standard 61010A-1, 61010A-2-20; Can/CSA C22.2 No’s 1010.1; 1010.2.20.
Tube Holder Configurations: The fixed-angle rotor that came with your Model 614B is capable of spinning test tubes up to 17 mm x 125 mm. Use the following chart and drawing to determine which tube holder and cushion combination should be used with your application. DIRECTIONS: 1. 2. 3. Compare the tube to be spun with the four boxes shown below. Find the box that most closely matches the tube’s length.