Instruction Manual

D. How to stop the receiver from sounding when bedwetting occurs
1. Press the "Reset" button of the receiver.
E. Channel selection
(The transmitter and receiver have been set on the same channel before delivery. They are ready for use. No pairing is required.
Should there be any interference from other wireless devices, you may change the channel. There are a total of 16 channels
available for selection.)
Change the channel setting by moving any of the channel switches to form any combinations.
Replace the back of the transmitter.
F. Low battery indicator
When the batteries are about to run out, the LED will flash 3 times every 10 seconds.
G. Replacing batteries for the transmitter
H. Powered by batteries or through an adaptor
I. Cleaning
as to maintain sensitivity. )
J. One-year warranty
3
2. Remove the wet material from the sensor. (If the sensor keeps attaching to the wet material, the receiver will go off every two
minutes.)
1. Remove the back of the transmitter
with a paper clip or a slotted screwdriver. Twist to open.
2. Change the channel setting for the receiver
to the one same as that for the transmitter.
As power consumption of the transmitter is minimal, batteries can be used for a long time. In case you need to replace the
batteries, open the back of the transmitter with a paper clip or a slotted screwdriver in the way as shown in section E.
The receiver can be powered by 2AA alkaline
batteries or through any smart phone adaptor whose output voltage is 5Vdc and
current is 0.5A or above. A USB cord is provided herewith for connecting the receiver to the adaptor (not inclusive) for powering.
1. Transmitter and receiver
: Use a dry cloth to wipe the surface. Do NOT immerse in water.
2. Sensor tip
: Use a damp cloth to wipe the sensor tip and let it dry naturally. (Note: The sensor tip should be cleaned regularly so
We offer you a one-year warranty for manufacturer's defects. For details, please visit our website www.bedwettingsolving.com
or contact us by email to [e-mail].