Operation Manual

Use

As Playback Device For Cassettes

If you want to use the device as a playback device for cassettes, you must either insert batter-

ies into the device or connect the device to your computer, which must be switched on, via

the USB cable which is also supplied.

Inserting the Batteries

The battery compartment is located behind the cassette compartment cover. You

require two 1.5 V batteries, AA type. These are not supplied.

1. Open the cassette compartment.

2. Use your nger nail to push the battery compartment cover in the direction of the arrow

and lift the cover up and off at the same time.

3. Insert two 1.5 V batteries, type AA into the battery compartment. Pay attention to the

correct polarity (+/–).

4. Close the battery compartment. The cover must be heard to engage in place.

Now insert a cassette into the cassette compartment, close the cassette compartment cover,

plug headphones into the device and start music playback by pressing the PLAY button.

Using the USB Cable

1. Plug the USB connector of the USB cable which is supplied into a USB port on your com-

puter, which must be switched on.

2. Plug the mini-USB connector into the USB port of the device.

Now insert a cassette into the cassette compartment, close the cassette compartment cover,

plug headphones into the device and start music playback by pressing the PLAY button.

As Converting Device

• Before you can digitise cassette recordings with the device, you must install the

software on your computer (see “Installation of the Software” chapter).

• Close all other programs which are running during the recording to ensure a

transfer with as little interference as possible.

1. Connect the device to your computer, which must be switched on. To do this, plug the

USB connector of the USB cable which is supplied into a USB port on your computer and

the mini-USB connector into the USB port of the device.

2. For Windows Vista and Windows 7 (for Windows XP go to step 3)

Set the device as the default playback device. To do this, go to “Control Panel” and open

the “Sound” window by double-clicking on it.