Operation Manual
23
The second time you use the program and thereafter, the program window which is shown
in step 4 will open directly after you double-click on the program icon.
4. Once you have conrmed your choice of language by clicking on “OK” or after double-
clicking on the program icon, the following program window will open:
A brief overview of the program functions can be found in the “Overview of the Software”
chapter. Set the record format and record volume you want if necessary.
5. Open the cassette compartment, insert a cassette into the device and then close the
cassette compartment cover again.
6. Wind the cassette to the point from which recording is to commence.
Wind up to a few seconds before the start of the track so that you do not miss
the start by mistake!
7. To start recording, press the PLAY button on the device and then immediately press the
“Record” button in the program.
If no tone curve is displayed during the recording, check whether the volume on
the device is switched on and whether the device is connected to your computer
correctly.
8. To interrupt the recording, click on the “Pause” button.
Please note: This does not stop the recording but merely pauses it. If you then
click on the “Pause” button again, the new recorded material is added to the
material recorded previously and this is later saved as one track.
9. To stop the recording, click on the “Stop” button in the program and then press the
STOP button on the device.
10. To listen to the recorded track, click on the “Playback” button.