FUNCTIONS 1. Power LED: Red light indicates power an, 2. Front Channel! High pass Frequency Control: This detentes knob controls the frequency of the front High pass-output from 32 Hz to kHz 3. Multiplier: This switch multiplies the Front Channel High pass Frequency Control from either 32-400Hz (1) to Switch to the left tn multiply (x 1} .and to the right to multiply (x20). 4. Parallel Input: This switch combines the From and Rear inputs Only one RCA pair is available for signal input.
FUNCTIONS 1. Front input: Gold plated RCA inputs. Plug in the RCA cables from the front channel of your radio here, 2. Rear Input: Gold plated FCA inputs, Plug in the RCA cables from the Rear channel of your radio here. 3. Mixed Output: Gold plated RCA inputs. Plug in the RCA cables here to get mixed in or out signal from the front input. You can use this to feed another crossover using same signal from radio. 4, Sub Low Pass: Gold plated RCA outputs. Run the RGA cable to the Sub woofer amplifier BCA input.
MOUNTING To prevent damage Ww the crossover while driving, mount I iy & secure place. Choosing the appropriate location will depend upon your vehicle dnd he: complexity of your stern design. Typical mounting locations: for your new crossover include the unk: or passenger compartment (oor or under seal). Never manta the component in & location that would subject if fo impression or BXpOEIE 1 Water. Nee a location has been chosen, securely mount the: crossover with. four gulling Straws.
MODE 2: Parallel Input ("IN” position) Front printout Rear Amp TROUBLESHOOTING SNE NG BOUND Is the LED i? YES RC Chigger input cables tor signal By Che power and Tremolos win-on wire corralling them straight tithe for voltage. Make sire drowning wire is sweater amplifier. secure. ANY SOUND NOW? Che for open fuse YES NO Problem is in the Gloss over Prohibition is elsewhere ii vibe system, Bes your [peal digitized {heck the bead withstand amplifiers, dealer.
