Speaker Timer with Remote Signal Light Model PRO-2000 PRO-2000T PSL-20V Model PRO-2000BT TR-2000BT PRO-2000TBT PSL-20V ASL2-ND3 ASL4-ND3, ASL4-ND3BT ASL-4
Using the Programs Quick Start - Set-up Programs are useful for debates or contests where pre-set timing formats can be selected quickly or where timekeeping is separate for each speaker. PROGRAMS (A) (B) Connect Signal Light to Limitimer with Cat-5 cable or Cat-5–to–XLR adapter KES 882 (included). To pre-set a program, select that program. INDICATOR Set Total Time, Sum-up Time, Blink and Beep. These settings are saved for the selected program. Plug in 12 V power supply (A).
Global Settings Default settings Global settings are common to all programs. They are made on the 12-position DIP switch on #1 2 3 4 on the rear of the timer console. The default settings (shown) are suitable for most uses. 1. Master / Slave. When two or more timers are connected to one or more signal lights, set one timer as master [ON] and the other(s) as slave [OFF]. When only one timer is used, it must be a master (default setting). 5 6 7 8 9 1112 4.
Signal Light Settings Signal Light Connections Use DIP switches on the bottom of the signal light to set which timer programs to display, whether sound cues accompany light changes, which phase lights are active and how the digital display behaves. All settings are local can can be different for each signal light connected to the timer. Connect the signal light to the Limitimer console with the 50-foot Cat-5 cable or the Cat-5–XLR adapter (both included).
Accessories and Options PSL-20V PSL-20VF Extra podium Signal Light Flush mount podium signal light for permanent installation ASL4 Audience signal light with 4” lights ASL4-ND3 Audience signal light with 4" digital display and green-yellow red lights. Audience signal light with 2” digital display and green-yellow red lights.
