Installation manual

Communicator Programming:
15
[347] Miscellaneous Maintenance Reporting Codes
I_______I_______I
Telephone Number 1 FTC Restore
I_______I_______I
Telephone Number 2 FTC Restore
I_______I_______I
Event Buffer 75% Full Since Last Upload
I_______I_______I
DLS Lead IN
I_______I_______I
DLS Lead OUT
I_______I_______I
Zone Fault Alarm
I_______I_______I
Zone Fault Restore
I_______I_______I
Delinquency Code
I_______I_______I
General Zone Low Battery Alarm
I_______I_______I
General Zone Low Battery Restoral
I_______I_______I
Installer Lead Out
I_______I_______I
Installer Lead In
[348] Test Transmission Reporting Codes
I_______I_______I
Walk Test End
I_______I_______I
Walk Begin
I_______I_______I
Periodic Test Transmission with Trouble
I_______I_______I
Periodic Test Transmission
I_______I_______I
System Test
I_______I_______I
LINKS1000 Test Transmission Code*
*The LINKS1000 Test Transmission Code must be programmed as “00” for the LINKS1000 Test Transmission to be disabled.
[349] PC5700 Maintenance Reporting Codes
I_______I_______I
PC5700 Ground Fault Trouble
I_______I_______I
PC5700 Ground Fault Restore
I_______I_______I
PC5700 TLM Line 1 Trouble
I_______I_______I
PC5700 TLM Line 1 Restore
I_______I_______I
PC5700 TLM Line 2 Trouble
I_______I_______I
PC5700 TLM Line 2 Restore
[350] Communicator Format Options
NOTE:The Third telephone number follows the format of the First telephone number.
Default
04
I_______I_______I
1st/3rd Telephone Number
04 I_______I_______I
2nd Telephone Number
01 20 BPS, 1400 HZ handshake 04 SIA FSK 07 10 BPS, 1400Hz handshake
02 20 BPS, 2300 HZ handshake 05 Pager 08 10 BPS, 2300Hz handshake
03 DTMF CONTACT ID 06 Residential Dial
Call Direction Options
Alarm/Restore Communicator Call Directions
NOTE: The LINKS1000 backup call directions will only back up their respective telephone numbers.
Section Partition Option: 1
1st Telephone
Number
2
2nd Telephone
Number
3
1st Telephone
Number (via
LINKS1000)
4
2nd Telephone
Number (via
LINKS1000)
5
Alternate
Communicator
6,7,8
For
Future
Use
Defaults: ON OFF OFF OFF ON
I________I
[351] 1
I________I I________I I________I I________I I________I I________I
[352] 2
I________I I________I I________I I________I I________I I________I