Installation manual

27
Basic Programming
To toggle options “ON” or “OFF”
press the corresponding number on
the keypad. Press [2] and the dash is
replaced by the number, indicating
the option is now “ON”. Press [2]
again and the number is replaced with
a dash, indicating the option is now
“OFF”.
Go through each of the options in the
section and determine if the option
should be “ON” or “OFF”. Once all
the options are selected correctly,
press the [#] key.
The keypad again displays “Enter
Section” followed by the three dashes.
To exit from engineer mode simply
press the [#] once more and the
keypad will revert to normal mode.
That’s all you need to get you started
programming the Power832 control
panel.
For complete details of all program-
ming options, refer to the Installation
Manual.
Basic Programming