User's Manual

Sennheiser Communications A/S
Industriparken 27, DK-2750 Ballerup, Denmark
www.sennheiser.com
Printed in China, 10/19, 770-00154/A04
EN
This device complies with Part 15 of the FCC rules.
Operation is subjected to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received,
including interference that may cause undesired
operation.
FCC User Information:
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device of the
FCC Rules, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV
technician for help.
Changes or modifications made to this equipment not
expressly approved by Sennheiser electronic Corp. may
void FCC authorization to operate this equipment.
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may cause
undesired operation of the device.
RF Radiation Exposure Information
Since the radiated output power of this device is far
below the FCC radio frequency exposure limits, it is
not subjected to routine RF exposure evaluation as per
Section 2.1093 of the FCC rules. This device complies with
the US and Industry Canada portable device RF exposure
limits set forth for an uncontrolled environment and
is safe for intended operation as described in the user
manual.
FR
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de
brouillage, et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
Information sur l‘exposition aux radiofréquencesn
La puissance RF rayonnée de cet appareil étant de loin
inférieure aux limites imposées par la FCC, il n’est pas
soumis à la réglementation sur l’exposition aux RF selon
la section 2.1093 de la réglementation FCC. Cet appareil
portatif est conforme aux limites d‘exposition aux
radiofréquences de la FCC et d‘Industrie Canada, définies
pour un environnement non-contrôlé et il ne présente
aucun danger au regard de son utilisation prévue décrite
dans la notice d‘emploi.
MB 110 WN (SCBT8)
Statements regarding FCC and Industry Canada/
Déclaration requise par la FCC et l’Industrie Canada