Model # DS18957 USE AND CARE GUIDE 5-LIGHT LINEAR PENDANT Question or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.
Table of Contents Table of Contents ........................................................... 2 Safety Information ......................................................... 2 Warranty ......................................................................... 2 Three (3) Year Warranty ............................................................. 2 What is Covered ........................................................................ 2 What is Not Covered ...................................................
Pre-Installation PLANNING INSTALLATION Read all instructions before installing. To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard. NOTE: This product requires five 60W maximum medium base (E26) type "ST64" (included) or type "A" bulbs or 9W maximum medium base (E26) self-ballasted LED bulbs (sold separately). IMPORTANT: Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have occurred during shipping.
Pre-Installation (continued) PACKAGE CONTENTS A B C D E F F F G H Part A B Description Butterfly nut (Pre-assembled to threaded tube (G-3/8”) (D)) Lock washer (Pre-assembled to threaded tube (G-3/8”) (D)) Quantity Part Description Quantity 2 E 6” tube 2 F 12” tube 6 2 G Fixture body 1 H 60W type “ST64” bulb 5 C Canopy 1 D Threaded tube (G-3/8”) 2 4
Installation 1 Preparing the mounting strip □□ Fasten the mounting strip (AA) onto the outlet box using two outlet box screws (BB). □□ Screw the threaded tube (G-1/2”) (CC) into the mounting strip (AA), and secure it using the lock washer (EE) and hex nut (DD). NOTE: The threaded tube (G-1/2") (CC) should extend long enough to protrude through the canopy (E) when it is mounted. (Adjust as needed.
Installation (continued) 3 Making the electrical connections □□ Strip 3/4 in. of insulation from the wire ends. □□ Connect the black wire from the fixture to the black wire from the outlet box, then connect the white wire from the fixture to the white wire from the outlet box. □□ Connect the bare copper ground wire from the canopy (C) to the bare copper ground wire from the fixture and the ground wire from the outlet box.
Care and Cleaning □□ Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully. □□ To clean the fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box. Use a dry or slightly dampened, clean cloth to wipe the exterior surface of the fixture. Troubleshooting Problem Possible Cause Solution The lights will not turn on. The bulb is burned out. The power is off. There is a faulty switch.
Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.com Retain this manual for future use.