Instructions / Assembly

FIXTURE INSTALLATION
Clip the wire clip (K) onto the
steel wire.
Adjust the steel wire to the
desired position as shown to ensure
that the pendant is level.


K
7900 N University Dr., Suite 202, Tamarac, FL 33321 USA
DSI Customer Service Hotline: [phone] ext 216 Mon. – Fri., 9:30 a.m. to 3:00 p.m. EST
Page 8 of 9
MADE IN CHINAMODEL : 16368
E
120V 60Hz
Install the light bulbs in the
Note: use only Max 40W type
Note: Do not touch the G9 xenon
bulbs with bare hands at any time.
A pair of white gloves has been
included for installation as oil
from the skin may damage the
bulb.
G9 xenon bulb. DO NOT use type
G9 halogen bulb without shield.
sockets.Uses 7 X 40 Watt Max G9
base xenon bulbs (included).

Hook 102 pcs 8 glass beads strand
(M) to the inside of the fixture
body (L) as shown in the diagram.

L
M
I
L
Note: please remove the
protective film from the inside
of top pan before hooking the
glass beads strands.
Place the canopy (J) over the
outlet box, let the threaded
tube (B) come through the hole
of the canopy (J) then tighten
the remaining hex nut (F) and
finial (G) to the protruding
threaded tube (B) on mounting
strip (A) until the canopy is held
firmly against the ceiling.

Cover the ends of the wires with
the wire connectors (H). Tape
the wire connector (H) and wire
together. Carefully position all
wirings inside outlet box.

B
F
J
G
A
H
FIXTURE INSTALLATION