Instructions / Assembly

MAINTENANCE AND TROUBLESHOOTING
Product maintenance:
To clean the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at
fuse box. Next, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the exterior
surface of the fixture.
Do not use any cleaners with chemicals, harsh abrasives, or solvents. Use only a dry soft cloth to dust or wipe
carefully.
Troubleshooting
Problem Possible Cause Solution
The bulb is burned out. Replace the light bulb.
The power is off. Ensure the power supply is turned on.
Faulty switch. Test or replace the switch.
The bulb will not light.
Faulty wire connection
Check the wire.
The fuse blows or a circuit
breaker trips when the light is
turned on.
Crossed wires or power wire is
grounding out
Discontinue use of the lamp.
Check wire connections.
Contact a qualified electrician or call the
Customer Care Service Team at
1-800-388-6141 ext: 216.
7900 N University Dr., Suite 202, Tamarac, FL 33321 USA
DSI Customer Service Hotline: [phone] ext 216 Mon. – Fri., 9:30 a.m. to 3:00 p.m. EST
Page 9 of 9
MADE IN CHINAMODEL : 16368
E
120V 60Hz