User manual

Eline User Manual
Page 10 of 16
Copyrights DSP4YOU ltd
3.2.1.2 Firmware upgrade
E-line firmware and Digital Signal processing embedded inside the device can easily be upgraded to new version
over the Ethernet. Click Browse to select the firmware you would like to upgrade the unit with.
Make sure not to un-plug the device during the firmware upload to prevent any corruption of the device.
3.2.2 Audio Video Bridging (AVB) stream configuration
The E-line AVB configuration requires limited setup. The following section will highlight steps involved in
building/deleting an AVB stream. Please refer to the
AVB primer for the basic terminology used through out this
section.
3.2.2.1 Build a Stream
Click on the “Configure AVB Stream” button to access the following dialog box.
2 simple sections: Talkers (source) on the left, Listeners (destination) on the right.
Select one Talker (i.e. Source) from the Talker list and drag&drop it in the “Drop Talker Here” box. Repeat the same
step for the Listener side (i.e. destination). The dialog box should now look like this:
To select one Talker
for configuration,
drag & drop action
as shown by green
arrow
To select one listener
for configuration,
drag & drop action
as shown by green
arrow