User manual

Eline User Manual
Page 2 of 16
Copyrights DSP4YOU ltd
Description
Featuring a mic/line input stage, phantom power and software configurable trim, E-Line fits the requirements of both
commercial A/V and I.T. installations. As a Power-over-Ethernet device, a single CAT5/6 cable on a 100Mb
connection provides audio, control and power to the device. Hardware isn’t the only innovative element of this
product. From network redundancy to our innovative auto-discovery protocol, E-Line provides un-paralleled level of
abstraction to get audio up and running. With our ZeroConf automatic configuration and hostname labeling of
devices, setup of an E-Line system is really only a drag & drop away.
Finally, aside from being a Plug&Play AVB-ready interface, E-Line answers the needs for small & low power Digital
Signal Processing (DSP). With our proven plug-in technology, DSP4YOU’s platform delivers flexibility without the
headaches of learning to program a new DSP platform. With the ability to upgrade plug-ins over the network, E-Line
will evolve over time to better fit your client’s needs.
Hardware
o 400MHz quad-core processor
o 2 x IN, 2 x OUT balanced configuration
o Software controlled gain trim (0/36/48dB)
o Software controlled Phantom Power
o 24-bit resolution - 48/96kHz sample rate
o 100Base-T Ethernet
o Redundant Ethernet connector
o Power-over-Ethernet (PoE)
Firmware
o ZeroConf setup
o Self discovery of device
o DHCP or Link Local addressing
o Plug&Play configuration
o Remote firmware upgrade over network
On-Board DSP
o 28/56bit fixed point DSP
o 48kHz sample rate
o Enabled based on the selected Plug-in (DSP configuration)
o Metering, Automatic Gain Control, Parametric equalizers, Compressor/Limiter, delay, phase, gain
System Diagram