Operation Guide

6
7
RF Exposure Compliance
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
The device has been tested for use against the body with 0mm separation in
Specific Absorption Rate (SAR) testing.
User must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier Trade Name:
Model No.:
LT330
Responsible Party
– U.S. Contact Information
DT Research, Inc.
2000 Concourse Drive, San Jose, C
A 95131
http://www.dtresearch.com
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the
following two conditions: (1) This device may not cause har
mful interference, and (2)
this device must accept any
interference received, including interference that may
cause
undesired operation.
FCC ID Label is in removable battery compartment, it could be easily found by
removing the battery cover.
RF Exposure Information(RED)
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 0cm must be maintained
between the user’s body and the handset, including the antenna.
The band 5150-5350 MHz for this device are restricted to indoor use only within all
European Union countries.
Hereby, [DT Research, Inc.] declares that the radio equipment type [LT330] is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address:
http://www.dtresearch.com.
Maximum EIRP for EU
Bluetooth:2402MHz-2480MHz
14.4dBm
Bluetooth LE:2402MHz-2480MHz
2.42dBm
Wifi: 2412MHz-2472MHz/2422MHz-2462MHz 20dBm
Wifi: 5150MHz-5725MHz
22.9dBm
Wifi: 5725MHz-5875MHz
13.9dBm