User's Manual

Version: 1.0
CAUTION:
If using a 100 x 100 VESA stand or arm, the VESA Conversion Bracket is needed. Please place
the VESA Conversion Bracket on the back side of the Cradle, and apply the four M4 screws.
CAUTION:
For proper operation, make sure all necessary connections are in place before powering on
the DT Research Tablet.
Inserting the Tablet into the Cradle
1. Use the key to unlock, and slide the latch on the bottom of the Cradle to loosen the Top Clasp.
2. Insert the bottom part of the Tablet into the cradle first with the connector parts correctly lined up.
3. When the bottom of the Tablet is in place, push the Tablet against the back and into the Cradle.
4. Push down on the Top Clasp, so the top portion of the cradle slides down and locks into the locked-down position.
5. Lock the Cradle with the key.
Releasing the Tablet from the Cradle
1. Unlock the Cradle with the key, then slide the latch on the bottom of the Cradle to loosen the Top Clasp.
2. Using two hands, hold the Tablet on both sides, pull the tablet up to remove the Tablet from the Cradle.
Specifications
Dimensions (H x W x D)
300*177*73 mm
Weight
1.1KG
Temperature
Operation: 0°C – 40°C; Storage: -20°C – 60°C
Humidity
0% – 90% non-condensing