User's Manual

DT395
The DT395
Input/ Output Ports
○
A
Headphone Jack
○
B
USB Ports
○
C
DC Power Input
Button Functions
 Programmable
 Programmable, launch soft (on-screen) keyboard (default)

Launch SAS (Secure Attention Sequence)
Generate Ctrl+Alt+Del keys to invoke the security windows defined under Windows XP
 Programmable
 Programmable, system utility menu (default)
 Programmable, As scanner trigger when equipped with the scanner module

Power on,
Push/release typically enters Standby mode, or Push/release exits Standby mode or
restarts device (software dependent)
Push and hold (over 4 seconds) invokes hardware shutdown
Power/Battery LED Status:
• Blue indicates the battery is 25% to 100% charged
• Blinking blue indicates the battery is charging
• Orange indicates that the battery is between 11% to 25%
• Blinking Orange indicates that the battery is below 10%
Precautions
• Always exercise care when operating and handling the DT395.
• Do NOT apply excessive pressure to the display screen.
• We recommend using the Stylus provided to keep the screen clean.
• Avoid prolonged exposure of the display panel to any strong heat source. Wherever
possible, the DT395 should face away from direct light to reduce glare.
• If the AC-DC power adapter is used to recharge or power the device, do NOT use any
AC-DC adapter other than the one provided with the device or acquired from the
manufacturer or its partners.
• In the unlikely event that smoke, abnormal noise, or strange odor is present,
immediately power off the DT395 and disconnect all power sources. Report the problem
to your device provider immediately.
• Never attempt to disassemble the DT395, as this will void the warranty.
ENGLISH 2 3 ENGLISH