Installation Guide

2
Button Functions
BUTTON ACTION
Power Buon
Programmable Buons
Baery Latch *Push the switch up to unlock the latch, then slide the latch le to remove the baery.
Input/ Output Ports
Headphone Jack
LAN Port
USB 3.0 Port
Smart Card Reader (DT301Y only)
DC IN Jack
1
2
3
A
B
C
E
D
Baery/Power LED
Brightness
Control buons
2
2
3
1
D
E
A
C
B
3
PRECAUTIONS
•
A
lways exercise care when operang and handling the DT301Y/ 301Q.
•
D
o NOT apply excessive pressure to the display screen.
•
W
e recommend using the Digital Pen (oponal) to keep the screen clean.
•
A
void prolonged exposure of the display panel to any strong heat source.
Wherever possible, the DT301Y/ 301Q should face away from direct light to
reduce glare.
•
I
f the AC-DC power adapter is used to recharge or power the tablet, do NOT use
any AC-DC adapter other than the one provided or acquired from the manufac-
turer or its partners.
•
I
n the unlikely event that smoke, abnormal noise, or strange odor is present,
immediately power o the DT301Y/ 301Q and disconnect all power sources.
Report the problem to your device provider immediately.
•
N
ever aempt to disassemble the DT301Y/ 301Q, as this will void the warranty.
BASIC FEATURES
The DT301Y/ 301Q rugged tablet integrates a bright display, USB ports, and
embedded networking elements such as wireless LAN or oponal 4G.
A DT301Y/ 301Q typically integrates an 802.11ac wireless LAN (WLAN) adapter
that may connect to other wireless devices or access points. If your DT301Y/ 301Q
does not come with such a network adapter, please consult your device provider to
establish the desired network connecvity.
NOTE:
To obtain protecon consistent with any IP rang for the device, the I/O (audio,
power, USB, card reader, etc.) port doors must be closed. If the IP protecon is
compromised by mishandling or misuse, such as by leaving port doors open or
improperly closed, any resulng product damage will not be covered under any
DT Research warranty.