User Manual

OPERATION
Powering ON and OFF
To acvate the DT313Y/ 313Q, push and quickly release the Power Buon. The display
will come on in a few seconds. To put the DT313Y/ 313Q in Standby mode, push and
quickly release the Power Buon. To turn the DT313Y/ 313Q o for extended storage,
power o safely using any soware funcon that “shuts down computer” provided in
the soware operang system.
NOTE:
The baery packs shipped with your tablet may be low in power—please use
the AC-DC adapter with the DT313Y/ 313Q when seng up for the rst me to
fully charge the internal baery pack.
NOTE:
When the baery pack is charging, the blue-colored Baery LED should blink
slowly. If plugging in the AC-DC adapter does not trigger this blinking acvity
and the LED stays dark, the baery pack may have been drained substanally.
Try unplugging/ replugging the AC-DC adapter to the DT313Y/ 313Q a few mes
to acvate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Buon to put the
tablet in “Standby” mode while not in use. Pushing briey on the same buon
will wake up the system within seconds.
4
Start Up
If the power up (from Standby mode or otherwise) is successful, the appropriate
interface will be displayed aer a launch sequence of several seconds. The wireless
LAN connecon may take 10-15 seconds to be established.
Configuring the Mobile Tablet
The DT313Y/ 313Q may be congured using the ulies and methods dictated by
the soware operang system. The DT313Y/ 313Q should be congurable for various
properes such as user proles, network features, and several system elements.
Wireless Networking
Wireless LAN
The DT313Y/ 313Q is oen delivered with an embedded (user-inaccessible) 802.11ac
WLAN adapter equipped with a hidden custom antenna.
•
T
hrough the support of typical WLAN adapters, the DT313Y/ 313Q should be able
to detect all 802.11 access points in the vicinity for you to select the access point
of your choice for connecon.
•
T
he SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT313Y/ 313Q
and the access points have to match. The SSID is case-sensive and it is recom-
mended that you enable WEP/WPA/WPA2 encrypon (or advanced alternaves)
for secure access.
•
W
hen WEP/WPA/WPA2 is enabled, you may need to consult your network
administrator or your networking equipment literature to properly congure
associated sengs such as Authencaon mode, etc.
•
R
efer to the access point operang manuals for seng up the 802.11 access
points.
NOTE:
For DT313Y, avoid using the Power Buon (“hold 4+ seconds” feature) to turn
o the tablet—this form of hardware shutdown is intended to be a means of
recovery from lockups, and not as normal operaon.
5