User`s guide

Rev Date 9/16/2010
36
3. When EAN.UCC Composite A/B is activated, deactivate Codablock F
4.
When MicroPDF is activated, deactivate Codablock F
5.
Code 39 and Codablock A cannot coexist
6.
Code 128 and Codablock F cannot coexist
Testing a Barcode Scanne
To test the bar code scanner, user can use WebDT Terminal
program or Keyboard Wedge.
r

Use WebDT Terminal-
To test the scanner module
with WebDT Terminal, the scanner has to be
disconnected with the keyboard Wedge.
1. Run the WebDT Terminal. Tap
Start
→
Programs
→
WebDT Terminal
.
2. Connect
Port
to COM1, set
Baud Rate
to 57600 (2D)/
19200(1D),
Data bits
to 8,
Parity
to None, and
Stop
bits
to 1.
3. Click the
Connect
button. The
Connect
button will be
changed to
Disconnect
after the scanner is
successfully connected.
4. Click
OK
to close the window and test the scanner by
pressing one of the side buttons. The output will appear
in the
Receive Data
field.
5. Verify the captured data.
Use Keyboard Wedge-
To test the scanner module with
Keyboard Wedge, the scanner has to be disconnected
with the WebDT Terminal.
1. Tap on the (Keyboard Wedge icon) on the task bar, and
make sure it shows
Disconnect Scanner
in the menu
list. If it shows
Connect Scanner
, then click on the
command to connect the scanner module.
2. Run Microsoft WordPad.
3. Scan a barcode and the barcode will appear in the
WordPad document.