User's Manual

18
SETTING THE INTENSITY LEVEL
It is very important to set the correct intensity level on
your R.A.P.T. Training System before beginning your
training sessions to provide the proper level of
stimulation without over-stimulating your dog.
1. Place the Intensity Selection dial so that the system
is set on Level 1.
2. Turn on the Collar Receiver and then fit it properly
around your dog’s neck.
3. Press the ‘Cont.’ button and check for a reaction.
Indications of your dog feeling the stimulation
include outward signs of discomfort or confusion on
it’s face, ears perking up, changes in tail
movements, etc.
4. If there are no signs of your dog feeling the
stimulation, increase the Intensity Level in
increments of one until your dog reacts to the
stimulation.
5. At this point, increase the Intensity Level by one or
two. This should be your dog’s ideal training level.
NOTE
Some dogs may require more or less stimulation depending
upon their individual temperament and/or size.
Setting the Jump Stimulation Level:
(R.A.P.T. 1400 and CoverUp only)
CAUTION: To avoid accidentally stimulating your dog,
please make sure that the collar is NOT on the dog
while setting the jump level.
7
Intensity Selection Dial - The
intensity selection dial can be set from
level 1 to level 16 to find the exact
stimulation level for your dog (see
page 18).
LED Indicator Light - The LED lights while pressing
any of the Transmitter buttons. The LED flashes
rapidly after pressing a button if the battery is low,
PARTS & FUNCTIONS
Continuous Stimulation Buttons - Pressing this
button emits a continuous stimulation while the button
is being pressed (up to an 8 second safety cutoff).
Collar Selector Dial with Lockout - Switching
between collar units can be controlled by toggling the
Collar Selecting Switch to the desired unit. Lockout
position prevents accidental button activations.
Battery Cover (Back of Transmitter) - Covers
battery and battery compartment. Held by 2 small
Phillips screws.
Rapid Access Button - Default setting is ’Nick’
Stimulation, which makes the collar emit a quick, split-
second stimulation. This button can be programmed
to be different functions as well (see page 19).
SureGrip Strap - Allows Transmitter to be worn on
hand for “hands-free” operation.
Magnet Indicator - White dot indicating location of the
magnet used to power ON/OFF the Collar Unit.