User Manual

ManualsBrandsDTC Communications ManualsElectronicsRemote Switch Encoder and Receiver

DESCRIPTION: OPERATION MANUAL,

RCT-1 SWITCH TX ENCODER AND

RCR-2 SWITCH RECEIVER MODULE

ECO NUMBER: _______

Page ______of_______

Date: ______________

Orig.: ____________

SIGN OFF DATE: mm/dd/yy

Proj. Eng._________________

Prod. Eng._________________

Mfg. Mgr. _________________

Documentation ____________

Eng. Mgr._________________

Purchasing _______________

Summary of content (6 pages)

PAGE 1
DESCRIPTION: OPERATION MANUAL, RCT-1 SWITCH TX ENCODER AND RCR-2 SWITCH RECEIVER MODULE ECO NUMBER: _______ Page ______of_______ Date: ______________ Orig.: ____________ SIGN OFF DATE: mm/dd/yy Proj. Eng._________________ Prod. Eng._________________ Mfg. Mgr. _________________ Documentation ____________ Eng. Mgr.
PAGE 2
01/08/02 RCT-1 Switch Encoder and RCR-2 Switch Receiver Module Detailed operating instructions, frequency and code options. Encoder The purpose of the RCT-1 Switch Encoder and RCR-2 Switch Receiver Module is to remotely activate audio transmitters, recorders, camera, encryption, and microwave video transmitter packages via a secure wireless link at distances up to 100 Meters. The handheld encoder is a license-free, Part-15 battery operated device with an integral rubber duck antenna.
PAGE 3
01/08/02 RCT-1 Handheld Encoder The Handheld Encoder is a remote control transmitter, which provides secure short-duration command signals for the Switch Receiver module. When used in conjunction with a properly deployed switch receiver, a range of more than 100 Meters is available (note: the antenna is not removable). The signal duration and power output of the handheld encoder is extremely low and the transmission is digitally encoded. The size of the units is 5.0 X 2.75 X .
PAGE 4
01/08/02 Controls The front panel of the RCT-1 has three switches and two LED indicators: ON-OFF This switch applies power to the device. When ON, the green LED will illuminate. VIDEO ON This momentary pushbutton sends the switch closure command (ON). VIDEO OFF This momentary pushbutton sends the switch open command (OFF). RED LED – This indicator will blink during the ON and OFF command transmissions indicating that data is being sent.
PAGE 5
01/08/02 Note: When this transmitter is operated in countries outside the USA with a 900 MHz GSM network, channels 5, 6 and 7 are preferred, since they fall between the TX and RX cellular band segments. Channel 0 1 2 3 4 5 6 7 Frequency 903.370 906.370 907.870 909.370 912.370 915.370 919.870 921.370 RCR-2 Switch Receiver Module The RCR-2 (Remote Control Receiver) can be operated from 6 to 16 VDC and draws less than 20 mA in all modes.
PAGE 6
01/08/02 Latching Relay Feature The Switch Receiver Module controls the power to the system via a latching type relay. This relay does not require power to remain in the last state that it was set to. That is, if it was set to provide power and the power source is removed, the relay remains latched.