User Manual

01/08/02
Controls
The front panel of the RCT-1 has three switches and two LED indicators:
ON-OFF This switch applies power to the device. When ON, the green LED will illuminate.
VIDEO ON This momentary pushbutton sends the switch closure command (ON).
VIDEO OFF This momentary pushbutton sends the switch open command (OFF).
RED LED – This indicator will blink during the ON and OFF command transmissions indicating that data
is being sent.
The command buttons (VIDEO ON and VIDEO OFF) should be pressed for a minimum of 2
seconds. Do not be afraid to send the command signal several times while changing position or
closing the package, if the receiver does not initially respond. ALWAYS TEST THE SYSTEM TO
ASSURE THAT THE ENCODER AND SW RECEIVER ARE SET PROPERLY AND FUNCTION
BEFORE DEPLOYMENT.
Keep the unit turned OFF when not in use.
Changing Channels or Address Code bits
The Channel and 8 Address Bits in the handheld encoder must be set to agree with the Switch Receiver
module code settings to allow control to occur.
To access the board for channel and address bit settings changes, first remove the battery door and the
battery and then the four Phillips head screws on the rear of the unit. Carefully split the two halves and
access the switches, being careful not to break or stress the wiring. After switch setting, re-mate the halves;
replace the four screws and the battery and battery door.
3