User's Manual

14
Introduction
DTC has improved the flexibility in the programming options you have on the
T-2350 audio transmitter. You can choose to use some, all, or none of this
flexibility.
When you order a T-2350 transmitter, DTC will factory program your frequen-
cies at no additional charge to you. You may want to place a sticker over the
rotary switch on the chassis, so users in the field don’t attempt to change
channels.
DTC will also provide you with free software and a free programming cable,
enabling you to change any programmable option. This is ideal if you often
work with other agencies, or anticipate the equipment being used by a multi-
jurisdictional task force. You can program up to ten channel settings per unit.
In general, this allows you to program at the depot for most variations you
might encounter in the field.
The configuration of each channel is managed with DTC programming
software. The programming software included with your T-2350 allows you
to do all of the following:
Programming
- Assign frequencies to each channel
- Select the mode of operation for each channel
(digital clear, digital encrypted, analog narrow or
analog wideband)
- Select the 56-bit DES-OFB encryption key and
16-bit key ID
- Select power level for each channel (High or Low)
- Select which microphone to use
(mic/antenna or alternate microphone).
TIP: Make sure that you program
your transmitter to match the
frequencies of your receiver, and
test the components as a system
prior to going into the field!
- Select Automatic Gain Control mode
(High Gain AGC, Low Gain AGC, No AGC
(Digital Clear/Encryption Only)
- Select LED operation
(normal operation or disabled)
- Enable/disable recording for each channel
- Turn on/off pre-recorded miniSD™ status and
battery status messages
- Set internal clock