User's Manual

19
Programming Options
Figure 3
Sets encryption key to be
associated with this channel
C
Select RF Power
Selects Modulations
mode
Enter frequency
in MHz
A
D
B
A. Selects AGC mode. In analog transmission
modes, AGC Off is not available and will operate as
LOW when selected. In digital transmission mode
all three settings are available.
B. Selects microphone or auxiliary input. When
selecting Internal/ALT1, the internal microphone will
be automatically selected unless there is an external
source connected to ALT1 on the circular connector.
In both settings, an external source will automatically
be selected when connected. When selecting
Antenna Mic/ALT2, you must have either the Antenna
Mic (DTC PN 7011149) or an external input source
connected to ALT2 on the circular connector.
C. Selects RF power operation when unit is in a low battery
condition. When the internal microprocessor detects that the
battery voltage has dropped below 4.1 VDC, the transmit
power will be controlled according to these settings.
Selecting Low Power or Off will prolong battery life, and will
not affect recording settings.
D. Record mode. Disables or enables recording on individual
channels. The Switched setting is intended to be used with
the optional remote recording switch.