Specifications

The EJECT button ejects the printer tray to the ejecting position. After the tray is

ejected, the EJECT light will turn on.

Always place the print media in the printer tray when the printer tray is at this

position, and press LOAD button to load the printer tray.

Please Note: When the printer is turned on for the first time, both the LOAD

and

EJECT buttons turn on. Press EJECT button to eject the tray and place

the print media, and the press LOAD to load the printer tray.

The INK FILL button charges the ink tubes & print head dampers with ink from the

ink bottles. Press and hold the button to start filling, and release to stop filling.

Please Note: Please check the waste ink bottle regularly during the filling

process. The filling process will push excess ink through to the waste ink bottle

There is no automatic mechanism for registering that the waste Ink

bottle is full.

Please Note: Press and hold the Ink button for three seconds to initiate the head

clean procedure after using the Ink Fill button.

 Ink Lights (1-7)

Each red ink light relates to a particular ink cartridge and indicates the status of that ink

cartridge. The flashing of any particular light indicates that its corresponding ink cartridge is

low on ink. It is important that you don’t allow any ink cartridge to run out of ink. If any light

stays on, shut the printer off for 60 seconds and then turn it back on. All the lights should now

be off.

Please Note: If all the lights start flashing quickly it means that there is an error in the

printer’s mechanism. Try the following to rectify the problem:

Turn off the printer, then open the printer cover and check the inside for

anything that may be blocking the printer head. If it appears to be okay, try

turning the printer on again. If the error continues please call our support

department at Impression Technology.

Please Note: If the lights flash alternately the printer may need adjustments.

Try turning the printer off and on again to rectify the problem. If the error

continues please call our support department at Impression Technology.