Owner`s manual

Troubleshooting
Problem Solution
Distribution Amplifier does
not operate
Make sure the 12V power is plugged in the back of the unit.
Check to see if the power LED light is on.
No picture (or signal)
Or Poor picture
1. In case your video source is HDCP enabled, make sure your
video display (HDTV) is HDCP compliant.
2. If you are using a copper based DVI cable, overall length of
the cables (length of the cable from video source to switch and
length of the cable from switch to display) should not exceed
20ft. Exceeding 20ft. with copper based cables will result in no or
poor picture quality. To extend beyond 20ft, please use fiber
optic DVI extension cables such as the Purelink HDX II series
3. Use high quality DVI cables.
4. If you are using computers, try other refresh rate settings.
Most HDTV’s have refresh rate of 48Hz and computer’s video
cards are usually set at higher refresh rate. Try lower refresh
rates.
5. Make sure all DVI connectors are tightly secured to all DVI
ports. Loosened screws on the DVI connectors will result in no or
poor picture.
6. Turn off all equipment (video source, switch and HDTV) and
restart all equipment.
Incorrectly sized picture
/resolution or No picture
Please remember that your video source will only transmit one
resolution setting. To connect varying resolution displays
(1920x1200 resolution display and 1024 x 768 resolution
display) the resolution setting of your video source must be set
to the lowest resolution setting (1024 x 768).
10