Instruction Manual

I_
505
_Aloxy Pulse
Instruction
Manual
EN
17
35
Step 2: Attach the mounting bracket to the asset
Depending on the type of asset and surface, the mounting bracket offers several options to attach,
either directly using plastic / metal straps, bolts / screws (M5), magnets or glue, either by using an
external metal bracket in between the mounting bracket and the asset surface.
󱛻󱛼󱛽 CAUTION
Before sliding the Aloxy Pulse device in its mounting bracket after installation, ensure the
mounting bracket is firmly attached on the asset and does not move when putting force in any
direction.
NOTICE
When the Aloxy Pulse should measure a certain motion, for instance the motion of the hand
wheel of a manual valve to monitor the valve’s position, make sure that the Aloxy Pulse device is
attached to the moving part and follows the same motion as the part it is monitoring. No other
motions are allowed after installing the sensor!
NOTICE
The following installation examples ensure a correct fixation of the mounting bracket to the
surface of an asset. Depending on the formfactor of the asset and the use-case, certain
attachment methods are more suited than others. For instance, to monitor vibration, the Aloxy
Pulse should be firmly attached to the surface of the asset to follow the same vibration pattern,
hence, options using glue or clips are not well suited.