Installation manual

DTS-6 Installation Manual Section 7: Diagrams
7-1
VII INSTALLATION DIAGRAMS
The diagrams on the following pages cover most installations. Contact DTS if the system
you are installing into does not appear. 70 MM spacer kits available, contact DTS.
Brackets for the DTS Timecode Reader Head
•
••
• D614 - Standard Bracket
For projectors: Century, Simplex, and Cinemeccanica with Kelmar bracket (below).
Intended to fit between the projector and reel arm. We have produced the bracket with
the American standard size hole to accommodate 2” center spacing 3/8 - 16 tap, that is
utilized to mount the American made upper reel arms. Comes with the following
hardware: QTY Description
2 10 x 24 x 1/2” long screw
2 3/4 x 16 x 1” long hex bolt nut
2 3/8” lock washer
•
••
• D615 - DP70 Universal Bracket
Used for American projectors with a penthouse. Comes with tap and drill bit 8-32, and
the following hardware: QTY Description
2 10 x 24 x 1/2” long screws
2 3/4 x 16 x 1” long hex bolt nuts
2 3/8” lock washers
•
••
• D616 - AA2 bracket
For Norelco AA projectors. Comes with the following hardware:
QTY Description
2 #10 lock washers
3 5/16” x 18 x 5” long screws
3 3/8” split ring lock
2 10 x 24 x 1/2” long screw
•
••
• D617 - DP75 Bracket
Used to mount the DTS timecode reader head to the side of the projector. Comes with
same hardware as the D614.
•
••
• D622 - Front Mount Bracket
Used when installing multiple digital sound heads or when there is not room to lift the
projector arm. Used with Dolby SR-D
TM
and Sony SDDS reader heads.
•
••
• 5006-0001-00 Cinemeccanica Bracket / adapter plate
For Cinemeccania projectors. Must be used with the D164 standard bracket for
mounting the DTS timecode reader head. If the reel arm needs to be remounted, two
plates are required. Note: Cinemeccanica also has their own brackets available.
Contact them directly.