Installation manual

DTS-6 Installation Manual
v
RACK-MOUNTED INSTALLATIONS
If this product is installed in a closed or multi-unit rack assembly, the following items must be
considered.
1. The ambient temperature within the rack may be greater than room ambient temperature. The
maximum temperature for the equipment in this environment is 50°C. Consideration should
be given to the maximum rated ambient.
2. Installation should be such that the amount of air flow required for safe operation is not
compromised, and that a hazardous condition is not achieved due to uneven loading.
3. Check nameplate ratings to assure there is no overloading of supply circuits that could have an
effect on overcurrent protection and supply wiring.
4. Reliable grounding of this equipment should be maintained. Particular attention should be
given to supply connections when connecting to power strips, rather than direct connections to
the branch circuit.
5. A quality surge / spike suppressor power strip is recommended to protect the DTS-6
processor.
SYSTEM CONSIDERATIONS
A DTS digital playback system can place enormous demands on the amplifiers and speakers in your
theater. Some of the factors that can effect the power requirements are speaker efficiency, room size,
and room acoustics. The following is a rough guideline of power requirements:
Each
Screen Surround
Theater Size Channels Channel Subwoofer
Small 200 WPC 200 WPC 400 W
Medium 300 WPC 300 WPC 600 W
Large 400 - 500 WPC 400 - 500 WPC +800 W
DTS SYSTEM SPECIFICATIONS
General Six channel configuration: left, center, right, left surround, right surround,
and subwoof. Holds two CD-ROM discs for up to 3 hours and 20 minutes
play time. One disc can play up to 90 minutes.
Frequency Response L, C, R:
20 Hz to 20 kHz LS, RS: 80Hz to 20kHz Sub: 20 Hz to 80 Hz
Dynamic Range: 96 dB, all channels
Size: 5 1/4” high, 19” long rack mount, 15 1/2” deep