Installation manual

DTS-6 Installation Manual Section 2: Unpacking
2-1
II. UNPACKING
The packaging is designed to handle normal shipping and handling. Upon receipt of shipment,
check for signs of damage before opening and report all damage to the carrier. All shipments
made from DTS are customer responsibility once they leave our premises.
Before installation is begun it is suggested that a complete inventory be taken to minimize
problems or questions during installation. Additionally, save all packing material until
installation is complete in the unlikely event that a component(s) requires return to the factory.
Use the packing slip that came with your unit to verify received inventory.
The following is a sample packing list for a single projector (platter) system:
• DTS-6 processor and power cord
• Timecode Reader Head
• Reader Head Mounting Bracket
• Manual
• Installation Hardware
• Reader Head Timecode Interconnect Cable, P/N D435
• 6-Track Output Cable, P/N D434
• 6-Track audio breakout card, P/N D437
• Logic breakout card (as it applies to your cinema processor)
• Stereo cable (if applicable), P/N D436
• DTS trailer (logo) films, two scope and two flat
If you have a two projector (change-over) system, you should receive an additional reader head,
mounting bracket, and hardware. Plus, the timecode cable will change to a “Y” cable.
If any of the items on your packing list cannot be found, contact DTS with the P/N and
description of the missing item(s).
Refer to “RETURNS,” page ii, when sending any product back to DTS.