User manual

DTS Broadcast PDH Microwave Digital Radio User Manual
-47-
6.1.2 SET
These parameters in the screens under SET menu can be edited, including local and remote IDU
or ODU.
Press ENT key when move cursor to SET menu in the screen “
” to
enter the screens under SET menu.
Failure will be occurred for modifying remote parameters, because communication of local to
remote are failed when changing several parameters of local. And most parameters will be stored in
EEPROM for Power-Down-Store. The following screens descript how to edit parameters under SET
menu.
This screen shows parameter of loopback configure. The parameter will be lost when power off
and is “Normal” when power on. Press ENT key if modifying required.
Use the
and keys to select the required loopback mode. Press ENT to set loopback mode.
Now the screen displays new loopback mode. The options of loopback mode are descripted in
table 6-1.
Note: Tributaries will be interrupted when loop back is configured. And the remote configure may
be restoring impossible when set one of remote loop back modes such as IDUIF, ODU_L at local.
Table 6-1 loop back items