User`s manual

ENTER

MENU Up-Down

Up-DownENTER

Up-Down

DMX Recorder Mode

For the programming of ChPr by using a DMX controller, besides the 10 channels necessary to control the unit a

further 3 DMX channels are needed.

So that in RECORDER mode (via DMX) the unit will need 13 channels to be correctly programmed.

The three new DMX channels are:

DMX channel 11 = SCENES channel

From 0-10 = no function (r001)

From 11-255 are displayed the programmable scenes (max 16 scenes from M001 to M0016)

DMX channel 12 = EDIT channel:

-From 0-19 = no function

-From 20-234 the unit runs the configuration given by the received input DMX values.

With the channel SCENES it is possible to pass from one step to the next while with REC it is possible to record

the selected scene.

-From 235-255 the unit runs the configuration given by the received input DMX values closing the sequence as

last scene.

With the channel REC it is possible to record the selected scene as last scene.

DMX channel 13 = RECORDING channel

Records the set scene with a variation between 0 to 255 (the display flashes indicating that the scene has been

recorded).It is advised that you keep the REC channel set to 0 and to run through the 255 only once you have

decided to save the scene. If ChPr is not closed, by indicating the last scene ( Edit channel between 235-255), in

playback mode all 16 scenes will be played through even if not programmed

Up-Down Up-DownENTER

ENTER

INFRARED MODE

Infrared remote control.

By activating Ir Mode, it will be

possible to navigate trought the unit

functions by using the D.T.S.

infrared remote control

(D.T.S. Code: 0514L008)

Note:

External infrared remote sensor

needed (D.T.S. Code: 03.LA.016)

NOT IMPLEMENTED ON SCENA LED 80 FC

SLAVE MODE

Slave mode for ChPr program.

All slave units will be synchronised

with master unit, running their own

Chpr program.