Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version 2.1
99 Document #: 9301E692002.1
7.6.2. Output Control Pins
This menu is used to assign functions to output control pins. When entering this menu the current
assignments are displayed next to the pin number, as shown below.
OUTPUT CONTROL PINS
► Out 1: Unassigned
· Out 2: Unassigned
· Out 3: Unassigned
· Exit Menus
Main Menu → Setup → Automation → I/O Control → Pin Definitions → Outputs
To change the pin assignment, move the cursor to the desired pin number and press Enter. A menu
will appear with a list of all of the available output pin assignments, as shown below.
Change Out 1
► (*) Unassigned
· ( ) End Pulse
· ( ) DTS Output
· ( ) ES Output
· ( ) Start Pulse
· ( ) CSS Enabled
( ) Video On
· Exit Menus
Options:
Unassigned Unused by XD10.
End Pulse Used for the end pulse during the video playlist automation
sequence.
DTS Output Output will be low whenever the XD10 is playing audio (or the
Blue DTS Playback light is on).
ES Output Output will be low whenever the XD10 is playing audio for
extended surround (soundtrack audio only).
Start Pulse Used for the start pulse during the video playlist automation
sequence.
CSS Enabled Output will be low when the CSS mode is either ON or
ONE SHOW and a subtitle language is selected. If the subtitle
language were set to Automation (Language Setup), then this
signal would be disabled if the selected automation subtitle
language is set to CSS OFF.
Video On Output will be low when playing video.