Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version 2.1
106 Document #: 9301E692002.1
7.6.4.4. End Pulse Enable
This menu allows the end pulse to be enabled or disabled for the selected playlist type. The End Pulse
must also be defined as one of the XD10 Control Output Pins. See Section 7.6.2, Output Control Pins.
<Playlist> Setup
Output End
pulse:
[Enable/Disable]
Main menu → Setup → Automation → Playlist (Option 4)
Options:
Enable End pulse is enabled. Pulse timing is determined by the end
pulse delay.
Disable End pulse is not used for this playlist type.
7.6.4.5. End Pulse Delay
This menu allows the control of the end pulse timing anywhere within 60 seconds before to 60
seconds after the end of the playlist. A negative value is used to indicate that the pulse occurs before
the end of the playlist.
<Playlist> Setup
End Pulse
Delay:
[ 60] Seconds
Main menu -→ Setup → Automation → Playlist (Option 5)
Options:
-60 to 60 Number of seconds offset between the end pulse and the end of
the playlist.
7.6.4.6. Lamp off
This menu defines if the video projector lamp will be turned off when the playlist completes.
<Playlist> Setup
Turn lamp off at
end of playlist?
[Yes/No]
Main menu → Setup → Automation → Playlist (Option 6)
Options:
Yes The projector lamp remains on at the end of the playlist.
No The projector lamp is turned off at the end of the playlist.