Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version 2.1
xii Document #: 9301E692002.1
If the Cinema Subtitling System (CSS) option is to be installed, complete the steps in Table 2.
Table 2. CSS Installation and Setup
Completed Task

 Install License for CSS Option
(CD-ROM)
Section 6.3, Installation of License Discs

Install Cable from EMA Control
Connector to EMA
Appendix J. Installing the CSS Option.

Install Cable from Subtitle Projector
to XD10
Appendix J, Installing the CSS Option.

Set Up the Subtitle Projector Section 7.4, CSS Setup

Position the EMA Mask Trims Appendix J, Installing the CSS Option.

Set Cinema Subtitling Projector
(subtitle) Language
Section 3.1.4.3, CSS Language

Check Cinema Subtitling Projector
(subtitle) Lamp Status
Section 3.1.4.4, CSS Lamp Hours
If the Video option is to be installed, complete the steps in Table 3.
Table 3. Video Option Installation and Setup
Completed Task

Video Cabling Appendix C, HD Video Interface Wiring Diagram.

Install the license for Video Option
(CD-ROM)
Section 6.3, Installation of License Discs

Configure the Video Output Section 7.3, Video Output Settings

Load Video Disc(s) Section 2.3.4, Loading DTS XD10 Video Content
Discs

Set Video Output Section 7.3.1, Video Output Settings

Set Playlist Automation Sections 7.5, Format / Automation and 7.6.4, Playlist

Play Test Images (Reset to Normal
when Complete)
Section 7.3.1.7, Video Test Contents
Caution Notices
Lithium Battery for the XD10 Motherboard: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.
Power Cord to the XD10 back panel: The power cord is the main disconnect device. It should be
plugged into an easily accessible outlet. The power cord is to be used in a minimum type SVT 18/3
rated 250 Volts ac, 10 Amps with a maximum length of 4.5 M, with one end terminated in an IEC 320
attachment plug and the other end terminated in a NEMA 5-15P Plug.