Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version 2.1
69 Document #: 9301E692002.1
7.1. TC (timecode) Reader Offset
This menu allows you to enter the offset required for your particular timecode reader location. See
Chapter 5, Section 5.5, Timecode Reader Sync Adjustment, for information on calculating the correct
settings. Adjustments can be made while playing and will occur within two seconds.
To access this menu, select TC Reader Offset from the System Setup Menu, as shown below.
TC Reader Offset
• 35mm
• 70mm
• SMPTE
• Exit Menus
Main menu → Setup → TC Reader Offset
Timecode Reader Offset Menu Overview:
35mm Set TC reader offset for 35mm reader head.
70mm Set TC reader offset for 70mm reader head.
SMPTE Set Serial number, reel number and offset for playback to SMPTE timecode.
7.1.1. 35mm or 70mm Timecode Reader Offset
This menu sets the timecode reader offset for 35mm or 70mm timecode reader heads. The operator
may select between either 35mm or 70mm reader heads through a menu in the Playback
→Film
section.
Set Timecode Reader
Offset (35mm):
[ 30.00] Frames
Main menu → Setup → TC Reader Offset → 35mm
Note the operation for setting the 70mm timecode reader head offset is equivalent.
Commands:
▲
Press one time to increase offset by 0.25 frames. Press and hold down to repeat.
Maximum possible number of frames is 100.
▼ Press one time to increase offset by 0.25 frames. Press and hold down to
repeat. Do not set below 10 frames.
Enter Return to Setup Menu.
Note: If not using 70mm, set the 70mm offset to match the 35mm. This will prevent problems
if the user selects 70mm by mistake.