Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version X1.0
F. Video Option Installation
Appendix
F.1. XD10 Video Option
The XD10 Video Option enables the XD10 to output digital video to a digital projector. Typical uses
may include theatrical pre-show material or special venue video presentations.
F.1.1. Field Installation for Type 1 Video Card
Required Components
1. DTS License for use of video option (a self-loading file on CD-ROM)
2. Video card
3. “Overlay” cable – provided with video card
4. Audio cable – short RCA Male to RCA Male provided with video card
5. Video cable to projector
At the XD10 end this must be 15 pin male cable; the projector end can be either 15 pin (typically
male), 3 BNC (RGB) or 5 BNC (RGBHV).
6. Projector (or monitor for test purposes)
7. If you are also using CSS (Cinema Subtitling) feature, extra hardware is required:
a. Video splitter (ATEN VS92A is available from DTS) with 12 VDC transformer
b. Extra Video cable (15pin VGA Male to female, 6 ft. length) (available from DTS)
F.1.1.1. Hardware Installation Procedure
1. Power down and unplug the XD10.
Caution: the XD10 front panel on/off switch does not remove power from the unit (it is a
standby mode switch). The unit still has power to the PCI slots when this switch is OFF.
2. Remove XD10 cover.
PRELIMINARY Information Document #: 9301E692001.0
F-1