Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version 1.0
Figure 4. (Before/After) Connect the arm to the support bracket.
(EMA shown not attached.)
3. Connect the projector to the DTS-EMA assembly. Secure using the three captive Phillips screws
(see arrows, Figure 5).
The projector must be installed upside down.
Figure 5. Secure the projector to the EMA.
4. Install the mounting plate on the wall, above the porthole.
a. While one person holds the mounting plate to the wall, a second person will support and
position the DTS-EMA assembly. Turn on the projector lamp, then position the projector and
external mask so that the image on screen is in the correct position.
Warning: Do not look directly into the projector light aperture.
b. You may want to loosen and re-tighten the set screw (step c, above) in the movable clamp, to
adjust projector position. Be sure to tighten the arm attachment (step d, above) once the
correct position is determined. Then turn off the projector.
c. Mark the wall for placement of the mounting plate. Mark the location of the 4 screw-holes
for the fasteners.
The Mounting Plate is 6 inches long (15.24 cm) and 8 inches tall (26.32 cm). It must be
mounted vertically, as shown in Figure 6.
Cinema Subtitling (CSS) Option Document #: 9301E692001.0
G-10