Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version 1.0
G.6. Regular Maintenance of the DTS-CSP System
Routine maintenance of the subtitle projector consists of keeping the lens free of dust and
inspecting the projector lamp.
The DTS-CSP subtitle projector lamp must be changed after 1400 hours of use. Failing to change
the lamp after 1400 of in-use hours may result in damage to the projector and is not covered by
warranty.
The XD10 CSS Lamp Fault red LED will flash, when 1400 in-use hours has been reached. The
same indicator will light continuously to indicate that the lamp has failed.
G.6.1. Routine Projector Lamp Maintenance
After every 100 hours of use
Warning: Wait for the projector lamp to cool, before inspecting and cleaning the lamp
module. A hot projector lamp can cause serious personal injury.
1. Vent screens on the module must be inspected. Any accumulated material (lint, dust, smoke
residue, etc.) must be carefully removed with a gentle vacuum cleaner or canned air and a soft
brush.
Note: If a large accumulation of dirt is observed, the inspection interval time should be
shortened with the objective of maintaining clean screens and vents.
2. Inspect the lamp bulb for any of these factors, and (if found) replace lamp:
• bulging
• white cloudy appearance
• blackened bulb
• bulbs with separated ceramic collars
3. The lamp module must be replaced after 1400 hours of use.
Caution: The lamp module must NOT be modified in any way. If the cover glass is missing,
removed or damaged, the unit will be damaged by excessive heat (and the warranty will be
void). Blocked or damaged lamp module screens can reduce lamp life or increase the
possibility of rupture containment failure.
G.6.2. Lamp Module Dust Filter Screen
After every 200-250 hours of use, in dirty environments
In dirty or dusty environments, the lamp module dust filter screen in the DTS-CSP projector can become
plugged, causing excessively high temperatures inside the lamp module. Excessively high temperatures
can cause premature lamp failure. Routine maintenance to remove dust and dirt from the filter screens
lowers the lamp operating temperature and lengthens lamp life. Clean the lamp module dust filter screen
every 200-250 hours when the projector is used in areas with high levels of airborne contaminants like
lint, dust or smoke. See TN-E538 in Appendix H of this manual.
G.6.3. Projector Lens Cleaning
The projection lens should be inspected regularly and cleaned by the approved cleaning method (soft non-
abrasive cloth and mild glass cleaner). If the projector will not used for a long period, cover lens with
lens cap.
1. Apply a non-abrasive camera lens cleaner solution to a clean, soft, dry cloth.
Cinema Subtitling (CSS) Option Document #: 9301E692001.0
G-17