Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version 1.0
YES – then go to step 10.
NO – then replace the fan.
10. During intermission, enable the test “Buzz And Bill” and watch for subtitles. Verify that the
subtitles are synchronized with the projected film. While test is playing, verify the function of the
DTS-EMA douser. It should open when it gets the command to open - which is when subtitles
are playing. Is the douser working properly?
YES – this is the end of this troubleshooting procedure.
NO – then call DTS Customer Support.
Subtitle text is distorted on-screen
1. Clean the lens on the subtitle projector.
2. If the image is fuzzy, recheck/adjust the projector focus adjustment.
3. Verify the PROJECTOR VIDEO cable is type SVGA 15-pin HD shielded with ferrite beads on
each end.
Caution: Do NOT make your own video cable. The cable requires special shielding and
ferrite protection.
Subtitle text is dim on-screen
1. Verify the DTS-EMA fan is rotating. If fan stops, the projector light will dim. If fan stops
rotating, replace it.
Note: The projector light intensity is always set to “high” unless the EMA fan stops running,
in which case the projector automatically switches to “low”.
2. Access the XD10 menu CSP LAMP STATUS and verify the number of lamp hours has not
exceeded 1400.
Note: The DTS-CSP lamp must be replaced after 1400 hours of use.
Subtitle text is not the correct size on-screen
Access the XD10 menu CSP SETUP, Image Size and select the appropriate image size. A higher number
will make the subtitles bigger and a smaller number will make them smaller.
Wrong subtitles are playing
Access the XD10 menu PLAYBACK | CSP LANGUAGE and verify the show language is available and
selected for play.
Note: The XD10 will always play the last language version loaded, unless another one is
selected from this menu.
The CSP LAMP FAULT indicator LED is blinking or is continually lighted
Access the XD10 menu CSP LAMP STATUS and verify the number of lamp hours has not exceeded
1400.
Note: The DTS-CSP lamp must be replaced after 1400 hours of use.
I’ve just replaced the projector lamp but it will not light
1. Go into the Current Lamp Hours display in the XD10 CSP Lamp Status menu.and verify that
the lamp counter has been reset to “0”. If not at zero, see the topic Reset the Lamp Hour Counter
on page A-G-20 to reset the counter.
2. Verify the projector is powered on.
Cinema Subtitling (CSS) Option Document #: 9301E692001.0
G-23