Specifications

XD10 Cinema Media Player, Installation and Operating Guide Version 1.0
3. Verify cabling is securely connecting the XD10 to the DTS-EMA and DTS-CSP. Check all 3
cables for broken wires.
4. Verify the DTS-EMA fan is turning. The fan cools the projector. If the fan is not rotating,
replace it. (See Appendix A, Replacement Parts listing.)
Light is leaking out around the subtitles on-screen
Reset the position of the magnetic trims on the DTS-EMA mask assembly. Use the test patterns in the
XD10 menu SETUP | CSP SETUP | Test Patterns.
Light is seen in subtitle area when no subtitles are supposed to play
1. The DTS-EMA douser is probably open. Be sure “Douser/Fan Control” cable is plugged in and
DTS-EMA fan is turning. Check cable for broken wires
2. Verify the XD10 menu SETUP | CSP SETUP | Test Patterns menu has been correctly exited. All
test patterns should be turned off.
3. Power off the subtitle projector until there is time to troubleshoot the problem. The DTS-EMA
solenoid could be bad.
Subtitles are cut off on the screen
1. Verify the physical positioning of the subtitle projector.
2. Verify the positioning of the DTS-EMA magnetic trims. Use the test patterns in XD10 menu
SETUP | CSP SETUP | Test Patterns.
G.10. Troubleshooting Rear Window (Captions) Option
No Rear Window captions
1. In XD10, verify the captions show is loaded on the hard drive and is enabled.
Note: The Rear Window option requires a separate license from DTS. The show must be
downloaded into the XD10 and enabled, and the Rear Window captions equipment must be
connected to COM1 connector on the rear of the XD10.
2. Verify the captioning equipment is powered on.
3. Verify the XD10 TIMECODE indicator is illuminated.
4. Verify the XD10 SERIAL indicator is illuminated.
5. Verify COM 1 cable is securely connecting the XD10 to the caption system. Check cable for
broken wires.
6. Refer to the caption playback equipment manufacturer for test procedure and troubleshooting
guidelines.
G.11. Troubleshooting Narration Option
No narration audio
1. Verify the narration transmitter is powered on.
2. Verify the narration headsets are connected and their volume is turned up.
3. In XD10, verify the Narration show is loaded on the hard drive and is enabled.
Note: The Narration option requires a separate license from DTS. The show must be
downloaded into the XD10 and enabled, and the Narration audio output connector on the rear
of the XD10 must be connected to the narration transmission equipment.
Cinema Subtitling (CSS) Option Document #: 9301E692001.0
G-24