Specifications

XD10 Digital Playback System, Installation and Operating Guide Version 1.0
2.4. Installation Procedures
Refer to the Installation Checklist on page ix near the front of this manual.
The DTS system consists of two major components: c DTS Timecode Reader Head and d DTS XD10
Cinema Media Player. The following is a generic procedure intended to supplement the processor
installation instructions for your specific manufacturer's system. Wiring diagrams are located in
Appendix B Installation Diagrams.
2.4.1. Preliminary Inspection
Before installing the DTS XD10, we recommend you take a complete inventory of system components to
minimize problems or questions during installation. Additionally, save all packing materials until
installation is complete in the unlikely event that factory return of parts is required.
2.4.2. Timecode Reader Head Installation
The Timecode Reader Head is designed to be mounted onto most projectors with a single mounting
bracket.
1. Position the appropriate DTS mounting bracket on the same bolt pattern as the reel arm and bolt
securely in place (see “bracket mounting diagrams” in Appendix B).
If both 35mm and 70mm reader heads are to be used on the same bracket, add spacer breakaway
plates to the readers. See DTS 35mm and 70mm Readers, Switchable, Using the Same Bracket, in
Appendix B.
2. Install the Timecode Reader Head onto the DTS mounting bracket and bolt into place with supplied
hardware.
3. Reinstall the reel arm on the top bolt pattern of the DTS mounting bracket.
4. Align the DTS mounting bracket and the reel arm. Align film along the path from the reel arm,
through the mounted DTS Timecode Reader Head, to the projector.
Important: The DTS timecode reader MUST have a straight film path (no angles or twists)
and at least a small amount of tension. Use the auxiliary flanged roller on the timecode
reader head to avoid film “walk out” and to stabilize the film. (See Installation Procedure –
Timecode Reader Head Auxiliary Roller in Appendix B of this manual.) Additional guide
rollers may be added to ensure proper film tension – this is most critical on platter systems.
5. Connect the 9-pin timecode cable and route to the sound processor rack for interconnect with the
XD10 player rear panel Timecode connector.
2.4.2.1. Two projector (change-over) theaters
Be sure to place each reader head at the same place on the projectors. In order for the
movie to play in sync, offset values must be the same for each projector.
2.4.3. DTS XD10 Player Installation
2.4.3.1. Rack Mounting and Connection
The DTS XD10 player is designed to integrate into your existing theater sound system, without affecting
normal theater operation. All interconnects are standalone, and most systems require no cuts or jumpers.
The XD10 requires 3U of standard rack space (5 1/4 x 15 x 19 inches) for proper mounting. Select a
space in the sound rack within three feet of the cinema processor to which you are connecting.
1. Bolt the XD10 into the selected rack space.
2. Check that the XD10 front panel power switch is in the OFF position.
3. Connect the supplied power cable between the XD10 and your power source.
Installation Document #: 9301E692001.0
2-5